JumperFree Configuration Settings
AI Overclocking: Manual
CPU Ratio Control: Manual
- Ratio CMOS Setting: 7
FSB Frequency: 499 boost from bios setfsb to 502.7FSB
PCI-E Frequency: 100
DRAM Frequency: DDR2-1248 setfsb to 628Mhz 5-5-5-9
DRAM Command Rate: 2T
DRAM Timing Control: Manual
CAS# Latency: 5
RAS# to CAS# Delay: 5
RAS# Precharge: 5
RAS# Activate to Precharge: 9
TWR: 3
TRFC: 30
TWTR: 3
TRRD: 3
TRTP: 8
DRAM Static Read Control: AUTO

Transaction Booster: AUTO
Boost Level: N/A
Clock Over-Charging Mode: AUTO

CPU Spread Spectrum: Disabled
PCIE Spread Spectrum: Disabled

CPU Voltage: 1.5375v
CPU Voltage Reference: x0.63
CPU Voltage Damper: Enabled
CPU PLL Voltage: 1.50
DRAM Voltage: 2.45 (added 0.05v just for precautions when setfsb is limited by mem clocks)
FSB Termination Voltage: 1.40
North Bridge Voltage: 1.70
North Bridge Voltage Reference: AUTO
South Bridge Voltage: 1.20

Advance CPU Settings
CPU Ratio Control: Manual
- Ratio CMOS Setting: 7
C1E Suppport: Disabled
Max CPUID Value Limit: Disabled
Vanderpool Technology: Disabled
CPU TM Function: Disabled
Execute Disable Bit: Disabled
PECI: Disabled

USB Configuration
USB Functions: Enabled
Legacy USB Support: Disabled (need to enable it to detect USB flash drives)

so I guess I should rip out the supertalents and drop in the Crucial Ballistix 8500.......??
hahaha.....when will this madness ever end

On Asus P5K-series there are two strap changes:

At 293FSB the board changes FSEL strap to 1333FSB to make more memory dividers available. This doesn´t have any effect to performance.

The performance level is also changed for following dividers:

1:2 Performance level changes from level 2 to level 1
Level 1 is the tightest possible, so expect some huge bandwidth

Dividers 3:5 & 1:2 are FSEL strapped to 800FSB.

At 500FSB the performance level of all dividers are set more loose.

1:1 Performance level changes from level 6 to level 10.
Level 10 is the loosest one. Usually the chipset can handle level 5 just fine

5:6 Performance level changes from level 5 to level 8.
Setting level 4 should not be a problem.

4:5 Performance level changes from level 4 to level 7.
Setting level 4 - 3 should be fine.

Since the memory frequency would get a bit high at bigger dividers I don´t have actual values for them. But I recon the values would be following:

2:3 Level 3 -> Level 6
5:8 Level 4 -> Level 7
3:5 Level 2 -> Level 5
1:2 Level 1 -> Level 4

The black slots are required for high memory clocks or stable low latency settings on either P5K board, in fact on the P5K3, the only way to get above 1800 in dual channel mode is to use the black slots. ASUS has the official explanation coming shortly...