youngpro

ah okay cheers

dinos22

one think i am not sure about is where to find it on nvidia

rivatuner doesn't seem to have LOD option in there

T_M are you doing the registry tweak or software

oohms

Another thing i think you can do but i havent tried, is to just run one game test at a time, and then when you have eventually run them all one at a time, in any order, it will give you a score.

Thats how you can adjust LOD and clock speeds etc for each game test

dinos22

yeah that's what i am going to do because when you run a flat LOD across the board some scores are much worse than normal level

but nature is very strong

oohms

Some voltmods:

http://www.vr-zone.com/?i=4641

dinos22

no pencil vcore mods

youngpro

dinos mate,

just though you might want to know,

i did those vgpu, vgmem mods today,

seem to work well, after the setup my default voltages are
1.85v mem
1.30v gpu

I had some problems with the vrzone ones though, they suggested 500ohm vr multiturn trimpot between the gpu point and ground, that took my resistance from 470ish to 330, and if my calcuations are right, and i turned on my card, my voltage would of been 2.2v into vgpu,

i ended up using the 500ohm vr trimpot (for fine adjustments), 10k vr trimpot, and 370ohm resistor in series to achieve the original 470 ohms, and i trim down from there to raise my gpu voltage,

so anyone thats doing vmods on the 8800 just beware you might require higher impedence resistors across the vgpu point or KABOOM!

youngpro

these cards have *bad* vdroop, 1.4v gpu at start, 1.37v in windows, between 1.345 and 1.328 under load...