You are not registered yet. Please click here to register!
Upgrading to Dell U2410s - i4memory.com - different look at memory

Notices

Rate this Entry

Upgrading to Dell U2410s

Submit "Upgrading to Dell U2410s" to Digg Submit "Upgrading to Dell U2410s" to del.icio.us Submit "Upgrading to Dell U2410s" to StumbleUpon Submit "Upgrading to Dell U2410s" to Google Submit "Upgrading to Dell U2410s" to Yahoo Submit "Upgrading to Dell U2410s" to Facebook Submit "Upgrading to Dell U2410s" to Reddit Submit "Upgrading to Dell U2410s" to Slashdot Submit "Upgrading to Dell U2410s" to MySpace Submit "Upgrading to Dell U2410s" to Twitter
Posted 14-07-2010 at 05:35 AM by eva2000

Two weeks ago Dell Australia had an end of financial year sale which effectively knocked ~32% off the RRP of their monitors - so I picked up 3x Dell U2410s

The monitors arrived around 2 weeks ago, but I've been very busy with work + relatives coming to visit these past 2 weeks, so only found the time today to open up one of the monitors and set it up to replace the position on my desk which had my BenQ FP2091 20" 1600x1200 monitor.

Guess the good thing about relatives visiting in that it forced me to get off my butt and clean up my room. First time in years you could actually see the desk or floor Had to get a 2nd desk to put up against my main desk to extend desk space from 120cm to 180cm.

Here's some photos below. Too busy with work right now to setup the other 2x Dell U2410 but hopefully get around to them

Cleaned up desk with old setup, 20" BenQ 1600x1200 + 22" BenQ 1680x1050 installed on Skunkworks.com.au purchased Marco gas assisted dual monitor C-clamp arm (purchased 6+ yrs ago).





Beautiful sight - 3x Dell U2410 1920x1200 monitors



Unboxing and testing of the first Dell U2410 before installing.



Dell U2410 menus













Vesa 100mm mount & Input connectors





Marco LCD arm mounting mechanism - simple installation, hold monitor in one hand and screw in screws with other hand.





Temporary setup for now as very busy with work etc. Eventually removing 22" BenQ 1680x1050 from right side and putting the 20" BenQ 1600x1200 to the right as it's shorter in width and will fit better. Then I have 2x independent Redleaf 13-30" desk C-Clamp mount arms for the remaining 2x Dell U2410

Posted in Displays
Views 4303 Comments 0
« Prev     Main     Next »
Total Comments 0

Comments

 

All times are GMT +11. The time now is 11:39 PM.